Must have plasma cutting accessories

Post by **pointsnorth** » Thu Oct 08, 2020 6:28 pm

Finally ponied up and bought my own plasma cutter. what’s everyone’s go to accessories.

Sent from my iPhone using Tapatalk

Post by **Scott Cee AKA 2drx4** » Thu Oct 08, 2020 8:22 pm

Uhh what did you buy?

Post by **pointsnorth** » Thu Oct 08, 2020 8:29 pm

Hypertherm powermax 45xp.

Sent from my iPhone using Tapatalk

Post by **Scott Cee AKA 2drx4** » Fri Oct 09, 2020 4:20 pm

That's the one I should have bought... Looks like not a bad deal from KMS right now?

Post by **pointsnorth** » Fri Oct 09, 2020 4:23 pm

Save your self almost 200 more and buy it through praxair over kms tools

Sent from my iPhone using Tapatalk

Post by **Scott Cee AKA 2drx4** » Fri Oct 09, 2020 4:27 pm

I'm not in the market but I'll keep it in mind. I bought my Thermal Dynamics unit from Western Gasco and they were under the MSRP at the time.

HMF · Post by **HMF** » Wed Oct 14, 2020 2:36 pm

Ummm just some cutting templates for that are a must have.... I know a guy...

Nice machine by the way

HillBilt · Post by **HillBilt** » Fri Oct 16, 2020 9:52 am

IMO thats the best unit for a home/fab shop.

I have circle/round radius stencils up to 2" as well as square. I use the circle ones ALL the time. Also have some aluminum strait edges 1' and 2'. Also a hand torch plasma water table, its super pimp and I havent even used it yet

4x4 North