![Image](http://uploads.tapatalk-cdn.com/20191006/e333d50e175d805d2252fe1d6f4a3cdd.jpg)
![Image](http://uploads.tapatalk-cdn.com/20191006/3d9ece9043b8e4d7fddd1af1cac42e77.jpg)
Getting the old one out was not so bad as my 36mm socket was exactly the right diameter to slide down the axle tube. Still working on how to seat the new seal... it’s located in the CAD housing and there’s no room to just “tap it in”. I wish it was the seal in the other side. At least then I could just remove ring gear and install the new one.
Sent from my iPhone using Tapatalk