Not a jeep person

[ridenby]

Started with a M1028, pretty nice one at that.

Got some front springs , shackle flip, cross over steering, started install all that. Got some hummv wheels and tires from Trail Worthy fab.

[Scott Cee AKA 2drx4]

Nice.

What next?

[HillBilt]

MOAR

[pointsnorth]

Nice build post up more


Sent from my iPhone using Tapatalk

[ridenby]

Went riding a few times. Found a few weak links. Was a little stiff in the steering. Had a trac-loc limited slip from the factory. Pick a wheel up in front and it was done. Decided a locker was needed. Went with a Grizzly, Yukon locking hubs. When I pulled the axles one u-joint was so stiff I could not bend it. Found a fellow selling RCV axles. Did king pins, bearings, spindles, cause why not,in there anyway. While I had the axle out went on and changed the cross member and engine mounts to ORD. Put an ORD steering brace in too. Used DIY4x4 rear shock mount.

Got a winch mount welded on the brush guard, Cheap 12000lbs china winch mounted to it.

trac-loc that was removed.

Why I drive a truck rather than do photography for fun money.

[ridenby]

I gathered up a few tools that beat the tar out of pry bars and cussing

[Provience]

awesome

what's the deal with the case spreaders? is it just an extra couple thou that it is able to flex the housing? looks like a pretty simple tool if it works good

[HillBilt]

I really like how you incorporated the winch mount with the factory bumper/bush bar, looks good.
Are all CUCV trucks diesel? pardon my ignorance but we dont really have any cool army shit up here

[ridenby]

awesome

what's the deal with the case spreaders? is it just an extra couple thou that it is able to flex the housing? looks like a pretty simple tool if it works good

Yes, once a little pressure is applied the carrier just comes right out or in. Get crazy with it and it can spring on even crack the housing,I am told.

[ridenby]

I really like how you incorporated the winch mount with the factory bumper/bush bar, looks good.
Are all CUCV trucks diesel? pardon my ignorance but we dont really have any cool army shit up here

All CUCV 1984-87 are 6.2L ,TH400, 208or 205 , Blazers/M1009 have 10 bolt rears, Pickups/M1008,1028,1031 have 60/14bff

[ridenby]

The ORD crossmember/motor mounts

Replaced the inner spindle bearing with delrin .

PSC pump, Hydroboost

[ridenby]

HUMMV tire and wheel.

[Scott Cee AKA 2drx4]

Do those derlin spindle bearings hold up well for regular use, or are they just better for people that run into a lot of water and mud?

[Provience]

awesome

what's the deal with the case spreaders? is it just an extra couple thou that it is able to flex the housing? looks like a pretty simple tool if it works good

Yes, once a little pressure is applied the carrier just comes right out or in. Get crazy with it and it can spring on even crack the housing,I am told.

awesome, thanks

[pointsnorth]

Actually most dealerships I’ve worked at are required to have a case spreader as part of their shop inventory but due too the chance of cracking or springing the housing it’s generally off limits for the most part


Sent from my iPhone using Tapatalk