Super Shopper Special

[HillBilt]

Worked on the “cold air intake” started hacking together the filter mount/heat shield




Should sit somewhere along the lines of this.


Pics make it look like the compressor is right up in there but it’s actually sitting down in the pocket


Sent from my iPhone using Tapatalk

[Scott Cee AKA 2drx4]

Looks like that should work good. I really need to change the setup in my XJ, I'm just asking to suck water with it.

[pointsnorth]

if you need a smaller dirtier filter I may have one

[HillBilt]

Had a bit of time last night to do a few things. Welded it together and started the intake tube, hacked up an old drive shaft for it and finished the small mounting tabs.


I did a few other misc items but nothing really pic worthy. Hopefully finish this junk up tonight


Sent from my iPhone using Tapatalk

[pointsnorth]

so we can expect hot laps thru the nieghborhood later tonight ?

[HillBilt]

so we can expect hot laps thru the nieghborhood later tonight ?

Ha, its a long ways from that, but hopefully sometime this year

[HillBilt]

So finished up two items on the list. Painted and mounted the compressor and mounting plate


And the intake. Had to up size the tube on the inside to 4” for the filter. Had some lefter over exhaust that worked minty




Added a bung for the valve cover breather and painted up.



Sent from my iPhone using Tapatalk

[HillBilt]

And mounted in




Crusty ole filter gets a bath next





Sent from my iPhone using Tapatalk

[Scott Cee AKA 2drx4]

Looks good!

Have you considered buying a better filter? I'm running a Volant Powercore, can't say enough good about it.

[Showtime100]

Needs more triangulation.

[Snowracer]

Looks good!

Have you considered buying a better filter? I'm running a Volant Powercore, can't say enough good about it.

Id start with just cleaning the filter he has as im sure that would be an improvement

[HillBilt]

Looks good!

Have you considered buying a better filter? I'm running a Volant Powercore, can't say enough good about it.

Id start with just cleaning the filter he has as im sure that would be an improvement

Thanks for the concerns about the filter boys obviously it will be getting cleaned as its covered in cobwebs from sitting on my shelf for the last few years. Its a K&N unit and will work just fine for my application with a good cleaning.

[Snowracer]

Looks good!

Have you considered buying a better filter? I'm running a Volant Powercore, can't say enough good about it.

Id start with just cleaning the filter he has as im sure that would be an improvement

Thanks for the concerns about the filter boys obviously it will be getting cleaned as its covered in cobwebs from sitting on my shelf for the last few years. Its a K&N unit and will work just fine for my application with a good cleaning.

the only thing that matters is that dirty air filter cause it might have the rona

[HillBilt]

the only thing that matters is that dirty air filter cause it might have the rona

with the way things are heading I’ll be using it as a face mask

[Sterlingfire]

If i was going to build s jeep the zj would be my only choice. Much nicer looking than any other jeep imo and v8 option is the only way to go. Looking nice so far