Toyodathon …a Toyota Truggy

[Johnny5]

The filler cap aint that fugly but that crusty old fuel pump is

[HMF]

The filler cap aint that fugly but that crusty old fuel pump is

I'm getting there dam it haha figured I would worry about finishing the fuel cell before dealing with how that looks

[HMF]

I'll play the do something every day game..

Made these bungs last night for my rollover valve.

Didnt like the bulkhead style that everyone seems the sell as the rollover ball is held on by the bulk head nut that in the tank and well it's a bulk head fitting.

So found this one from jegs..

its a bulk head fitting but I can just not run the nut in tank and thread it into these bungs I made for a secure connection. Plus with the baffles I can really get to a bulkhead fitting to tighten it. :ideas

Tonight is the filler neck nipple for the tank and fill vent nipples. Then this weekend I can finish the fuel cell finally and start back up on the tube work to mount it all

[HMF]

Slow weekend in the shop but got the fuel cell all welded up so next weekend is the back tube work.

Added some HMF touch to it

There's your crack for the week boys and girls

[HillBilt]

Did you stamp that? Looks mint

[HMF]

Yep there is one on each side

[Scott Cee AKA 2drx4]

How'd you make the die(s) for stamping it? Pretty cool.

[HMF]

Its just a couple pieces of plate and used my shop press

[HMF]

Well got my rollover valves from jegs...

Have to cut out the bung I welded in for them as their web site gave me the wrong info about them for thread specs and sizing

[HMF]

Well it was a busy weekend in the HMF shop. Friday I cut Mr Gutsys winch bumper and some kingpin washers for snow racer. Also made this fire pit for my work that will be up for silent auction at the spruce city wildlife fundraiser next month.

[HMF]

So Saturday and Sunday I worked on the truck and got a bunch done... found the limits of my JD2 notch master doing offset notches and high angle notches for bracing. Options are I need to buy the swag offroad reach around attachment or make my own... or buy a new notcher( not in th cards right now)

Rear halo is fully welded just not to the truck still just tacked on. Tape is braces I still need to weld in. Everything fits, its tight but it all fits and I can still see out the back window so pretty happy with that. Trans cooler will be on the cab side of the rad. I have to shorten the winch drum on my smitty xc 9500 to fit in behind the batteries but that's fine I've done it once before so womt be hard. Got the trans lines figured out not going to be cheap but will be nice and tidy when it's all done.

[HillBilt]

Damn dude, thats looking
Pretty sure you could whip up that notcher attachment quite easily

[Mr.gutsy]

looking-good-b41068-3.jpg (55.83 KiB) Viewed 3486 times

[HillBilt]

looking-good-b41068-3.jpg

You taking selfies in the shop again?

[HMF]

Damn dude, thats looking
Pretty sure you could whip up that notcher attachment quite easily

Yea I'll do some digging around at work tonight to see if I can find some 3" x3/4" cold rolled flat bar. If not I might have to make some