2020 Insanity Fab Winter Challenge Prep

[Snowracer]

those locking dipsticks? been thinking about getting one for my trans and trying to make my engine one into a locking one some how as cant buy one to fit my oil pan

[Scott Cee AKA 2drx4]

Here's where my failure was on my steering mount. All 3 of my TMR tube clamps bent up

Interesting. I've always been suspicious of those clamps and that would confirm my fears.

[HillBilt]

those locking dipsticks? been thinking about getting one for my trans and trying to make my engine one into a locking one some how as cant buy one to fit my oil pan

Yeah both of them. Been long over due, my trans is one I sourced from the junkyard as all aftermarket cheap stuff is shit and motor one spits out when shes hitting the high Rs. Theyre pimp

[HillBilt]

Here's where my failure was on my steering mount. All 3 of my TMR tube clamps bent up

Interesting. I've always been suspicious of those clamps and that would confirm my fears.

Yeah, they have their place, but I was hoping they would hold up a bit better. Only driven the truck a handfull of times since I installed them. Im just going to bend them back strait and weld the bottom clamp up. Will just have to zip cut the weld when I have to remove it for now

[pointsnorth]

i was just about too post weld a 1 inch bead lol

[HMF]

Yep way too much for a dipstick but dam they are nice. Dont regret getting the one for the 4runner at all

[HillBilt]

I plan to change my trans cooler lines to rubber hydraulic lines. Swapped the pump fittings on the transmission to accept the new lines. Upped the line size by a bit also.



Sent from my iPhone using Tapatalk

[HMF]

Nice that should help not spray red gold everywhere

[HillBilt]

Nice that should help not spray red gold everywhere

Hahaha, right!


Sent from my iPhone using Tapatalk

[HillBilt]

Few teasers HMF sent me of my wheels he’s working on today








Sent from my iPhone using Tapatalk

[Scott Cee AKA 2drx4]

[Snowracer]

cage is pretty close to done now

[Scott Cee AKA 2drx4]

cage is pretty close to done now

You going to tie into the shock mounts in the back then?

[Snowracer]

cage is pretty close to done now

You going to tie into the shock mounts in the back then?

yes thats the plan. will cut the a pillar/roof bars back flush and Mr HMF is going to make me weld slugs so i can sleeve the down bars onto them

[HillBilt]

HMF killed it on my H1 re-center kit now I have to find some PVC for inserts




Sent from my iPhone using Tapatalk