![Image](https://i.imgur.com/jVJ1PEoh.jpg)
Problem is it didn't go high enough. And the pad on it was so poorly secured/fitting that it would tip and cause the jack to slip off an axle tube. Absolute shit design.
![Homer :homer:](./images/smilies/homersimpson.gif)
Not wanting to spend money on this I dragged out some scrap. Yes, that's an ABS tone ring from a ZJ. I knew it would come in handy some day!
![Image](https://i.imgur.com/MaDhlzzh.jpg)
Stacked it all up like this.
![Image](https://i.imgur.com/N4Dd0wPh.jpg)
Then used the Curtis Warner approved method of "Just pile the weld on and hope it holds" to stick it all together.
I then bolted this abortion on so it can't rock or slip.
![Image](https://i.imgur.com/RPDqWy7h.jpg)
At least it actually works now.
![LMAO :lmao:](./images/smilies/laughing2.gif)