4x4 North

Rolling chassis as in axles, suspension, frame. Single wheel D70 and D60 combo.

Will take it to scrap soon. Basically give me what the scrap value is and I'm good.

EDIT - Went to scrap.

99 has the unit bearing front end?

rammaninc makes a ford unit bearing conversion kit but to me all they have done is drilled out the dodge bolt pattern in new ford unit bearings and supplied ford stub shafts

Its unit bearing. You can put the pre-Superduty BJ knuckles on it to go to conventional hubs, and I think the 99-04 Superduty outers fit on it to get unit bearings with selectable hubs. Either way not a great axle.

Going to scrap tomorrow AM.

Balls. What's scrap on this? I might be in pg saturday

Shancerlelby wrote: ↑Thu Sep 26, 2019 11:34 pm Balls. What's scrap on this? I might be in pg saturday

Probably under $100. Steel typically isn't that much. It's pretty thrashed stuff, although the frame was straight.

But it's too late. It's on the trailer and strapped down. I've got a mill to pick up tomorrow so I needed it out of my shop, and need the trailer to get the mill, and can't really move it out of the shop unless it's on the trailer. Sorry I didn't post it sooner but I hadn't decided what I was going to do.

No worries dude! I find no one wants my junk till it's gone lol